The primary difference is the customizability of a single wire system.Warmtech is Australia’s leading supplier of electrical radiant underfloor heating systems.Įlectric underfloor heating provides more additional benefits than any other form of home heating. Single wire systems work and install similarly to electric mat versions. This will prevent overheating of the wire and issues with the thermostat. Using scissors, trim the mat so that the wire is no closer than 4” to a fixture or baseboard and no closer than 2” to another wire. Do not overlap the mats, as this will cause an uneven floor and cause problems with the flooring later. Now lay the mat out on the floor and see what needs to be trimmed. If your system fails this test, do not use it. Using a multimeter, check for continuity from one end of the wire to the other. These wires will be woven into the mat during manufacturing, so locate both ends. The wires used in electric mat heating are relatively small, and can be damaged during shipment. Now that you have the square footage to be heated, you can select the materials or kit based on your project. This will provide the area to be heated (if you are just heating a small area in front of a tub or shower, you can skip this step). Now deduct the area occupied by a fixture, such as a tub, vanity, or pedestal sink. Measure the entire bathroom the system will be installed in. We’ll assume you have gained access to the concrete pad or wooden subfloor and are ready to measure.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |